mySoftware [Updates]

Once you create a user profile on Motifator and update with the appropriate information, the updates shown here will be specific to you.

newProducts [YOK]

rssFeeds [Syndicate]

Welcome to the support section.

Bank Select and Program Change

Bank Select – Program Change
Bank Select-Program Change events can be inserted on any MIDI track to recall a specific Voice. These are fairly easy to work with on Yamaha sequencers - as Yamaha uses what is called a “packed” event (be sure to check the documentation of your sequencer if you are using an external device to sequence your data).

Bank Select is a two byte Control Change (cc) message - a MSB (most significant byte) and a LSB (least significant byte) these two Control Change message each will have a value. This value identifies the bank. Messages will be between 000 and 127. The Bank Select information is followed by a Program Change number (also a number between 000 and 127)

The format is “xxx-yyy-zzz”
‘xxx’ is the MSB value
‘yyy’ is the LSB value
‘zzz’ is the Program Change value

You also will find some sequencers use the long form which involves Control Change 0 (MSB) with a value, followed by Control Change 32 (LSB) with a value, followed by the Program Change event.
Check your sequencer’s documentation for how to input Bank Select and Program Change commands.

All normal GM sounds are in MSB = 000, LSB = 000
The GM Drum kits are in MSB = 127, LSB = 000

So a Program Change message in the Yamaha sequencer that is:
000-000-000 will recall the GM bank piano

The long form for the GM piano would be:
Control Change 0, value 0
Control Change 32, value 0
Program Change 0

A Program change message in a Yamaha sequencer that is:
127-000-000 will recall the GM Drum Kit

The long form for the GM Drum Kit would be:
Control Change 0, value 127
Control Change 32, value 0
Program Change 0

In Yamaha synthesizers with Preset Banks, User Banks, Preset Drum Banks, User Drum Banks, etc. you will find they follow this format:

image

Although sounds listed in the Banks of the Motif XS have numbers from 001 through 128, the actual data that you enter into the sequencer will be counted starting with Program Change 000. So the sound located in the XS as sound 001(A01) will actually have a Program Change value of 000. (Simply subtract 1 from the location number)>

As an example, if you wanted to recall the “Full Concert Grand” piano Voice PRE 1: 001(A01) on a track, you would insert the following data at a musically appropriate time:

From the main SONG or PATTERN screen
Press [EDIT] to view the EVENT LIST
Press the Track button [1]-[16] to select the Track you wish to work with
Press [F5] INSERT
Select the EVENT TYPE = PROGRAM CHANGE
At the appropriate Measure-Beat-Clock set the values
063-000-000

You cannot have the Motif XS change programs in the middle of a note, nor can you have it change programs and play a note simultaneously… therefore, a musically appropriate time is one where the instrument change does not negatively affect the music you are hearing. If there is a musical rest (pause) of approximately a 64th note you can usually insert a Program Change event. That is much faster than a human being can actually switch instruments. So in most normal instrument change scenarios you can use Program Changes to accomplish an instrument change. Of course, it will depend on your tempo - so the mileage will vary. If you hear a hiccup then you have not placed this event in a musically appropriate time in the music. 



Permalink