Old Motifator threads are available in the Archive.
tojoba
Total Posts: 8
Joined 06-04-2011 status: Newcomer |
I have created a couple of songs from Performances on my Motif XF. Each song right now is just the four Parts from the Performances. I’ve set up the Mixer on the Motif for each song so that Part1 is routed to FW1 & 2, Part2 = FW3 & 4, Part3 = FW5 & 6, and Part4 = FW7 & 8. My settings in the Utility mode are for all FW outputs to have +6 dB gain. When recording either of the songs into Logic, my first pass at recording these four stereo tracks came back with a pretty low recording level. The highest peak on any of the four tracks was around -19. When I looked at the Mixer on the Motif, I noticed that the faders for each Parts 1-4 were varied due to, I presume, the settings from the Performance. So, I increased each fader for Parts 1-4 to max values of 127 and re-recorded the tracks. I did notice higher peaks this time. The highest peak was now at -9. The sound quality was very good but when compared to other tracks in my project, the four tracks are noticeably lower. Is there anything else I should check? |
motif8mine
Total Posts: 1743
Joined 10-22-2004 status: Guru |
see below...
|
motif8mine
Total Posts: 1743
Joined 10-22-2004 status: Guru |
or this:
|