When you are using the Motif-Rack XS with the Yamaha Steinberg FW driver (YSFW) you need to verify the following settings in your Motif-Rack XS:
Press [UTILITY]
Select “GENERAL”
Press [ENTER]
On page 2 of 5 (2/5) ensure that the IEEE1394 Driver = FW
If not, change the setting, then press [STORE] to write this preference to your Flash ROM
You will need to reboot the Motif XS for this setting to take place.
Next, you want to make sure that the MIDI communication is set to mLAN:
Press [UTILITY]
Select “MIDI”
Press [ENTER]
On page 1 of 6 (1/6) ensure that the MIDI IN/OUT = mLAN
Press [STORE] to write this preferecne to your Flash ROM.
Now, let’s setup your Macintosh computer:
Go to SYSTEM PREFERENCES in your Dock
Find the Yamaha Steinberg FW icon listed in the “OTHER” category
Double click the icon to open the panel.
Here you will be able to set the Sample Rate (44.1, 48, 88.2 or 96kHz), the Word Clock Master (Motif-Rack XS), and the Clock Source (Internal)
Click on the tab(s) that identifies your connected device(s): Motif-Rack XS
The current IEEE1394 Firmware version of your mLAN16E2 will be shown. This should read: V1.07 currently
Now that we have verified that the Yamaha Steinberg Firewire driver is in place, lets make sure your Macintosh is set to use it.
On your Macintosh HD, go to APPLICATIONS > UTILITIES > AUDIO MIDI SETUP
On the AUDIO DEVICES tab select the Yamaha Steinberg FW driver as your audio device.
Close AUDIO MIDI SETUP.
Launch Cubase
Go to DEVICES > DEVICE SETUP… > MIDI > MIDI Port Setup
Here you will be able to select the device(s) that will be your MIDI controller. Typically this is any MIDI controller connected to its back panel jack Motif-Rack XS MIDI IN and/or you may wish to select the Motif-Rack XS Main (this is so you can record knob movements to tracks or as automation within Cubase).
Make sure that only these devices are marked in the “In ‘All Inputs’” column
Move down to the VST AUDIO SYSTEM item and verify that the Yamaha Steinberg FW is selected as the ASIO DRIVER.
The option just below VST AUDIO SYSTEM will be “Yamaha Steinberg FW”. If you highlight that you will see the CONTROL PANEL where you can set your buffer size.