Old Motifator threads are available in the Archive.
johpat
Total Posts: 61
Joined 10-08-2003 status: Experienced |
Hello
I have a question how i can block orders from my keyboardkeys to my cubase elemtent 10. For example if i push a E key or a F key it chance windows in cubase.
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
The problem is caused by incorrect MIDI port setup - Inputs should be Port 1 (Yamaha MOXF6/MOXF8-1) and possibly Port 3 (only if there’s another keyboard connected to the MOXF’s 5-pin MIDI-in). Make sure Ports 2, 4, and 5 are not selected. For Remote Devices, only Port 2 (Yamaha MOXF6/MOXF8-2) should be active, both for In and Out. Ports 1, 3, 4, 5 should not be selected. See MIDI channels and MIDI ports on page 54 of the MOXF Owner’s Manual. |
johpat
Total Posts: 61
Joined 10-08-2003 status: Experienced |
Hello 5pinDIN, I’ve got it. I have change in utility of th moxf under the midi (F6 buton) the “KBDTransCh†change from “1“ to “OFF†Problem solved Thanks a lot, I’m so sorry it is’nt solved. |
johpat
Total Posts: 61
Joined 10-08-2003 status: Experienced |
Sorry i have change it in channel 16 because otherwise i don’t get a midi signal in my cubase |
johpat
Total Posts: 61
Joined 10-08-2003 status: Experienced |
|
johpat
Total Posts: 61
Joined 10-08-2003 status: Experienced |
|
johpat
Total Posts: 61
Joined 10-08-2003 status: Experienced |
Yesss 5pinDin I have change Remote Device midi input and outtput in Yamaha MOXF6/MOXF8 8-2 and its work Thanks |
johpat
Total Posts: 61
Joined 10-08-2003 status: Experienced |
Only if push my sustainpedal it mut an audio track |
johpat
Total Posts: 61
Joined 10-08-2003 status: Experienced |
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
The cause may be routing of a Generic Remote Device. If you’re not using it, set its MIDI Input to “Not connected”. |
johpat
Total Posts: 61
Joined 10-08-2003 status: Experienced |
Thank you 5pinDin |