Old Motifator threads are available in the Archive.
bfernandes70
Total Posts: 1
Joined 02-08-2020 status: Newcomer |
I have my set list setup in Master mode on the MOX. Each master has the Zone Switch On. Zone 1 is my MOX sound playing either a Voice or Performance. Zone 2 sends the Program Change information for an external keyboard (Juno DS88) on a different Midi Channel (5). I just want the program change to occur. I don’t want the MOX to play that sound in tandem. Can I not have that happen or should I look to Albeton to Change all my Program sounds so they stay independent. HELP! |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
Welcome to the forum. Zone 2 can be edited to accomplish what you want. You can prevent the MOX keyboard from playing Zone 2 (MIDI channel 5 assignment, in your case) by editing the Low Note Limit. The default is C-2 - change that to G8. See [F2]NOTE on page 130 of the MOX Reference Manual. In addition you’ll probably want the MOX’s controllers (Pitch Bend, Mod Wheel, etc.) to also not send on Zone 2 (Ch 5). They can be turned off via the Transmit Switch. See [F3]TX SW on page 131 of the Reference Manual. |