Old Motifator threads are available in the Archive.
mkeschinger
Total Posts: 73
Joined 10-25-2011 status: Experienced |
Title says it. LoadinG xpand. Both under 500mb says its full.
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
I presume that by “xpand” you’re referring to the “XSpand Your World” library. (If not, then please tell us what.) Note that the first two letters of that title are “XS”. Since the XS doesn’t have flash modules, by default samples are loaded to SDRAM. That will also be true when loading that library to an XF unless you change the Load destination. The XSpand library is about 400 MB, but the XF has only 128 MB of SDRAM, hence the error message.
Default Load options at lower right of the screen are…
To redirect XSpand samples to your flash module, change to…
Â
I presume the reference is to Bank 2 of “Inspiration in a Flash”. Without knowing exactly what procedure you used, it’s difficult to determine what went wrong. The default Load options (above) normally should result in the samples being installed to the flash module.
This support article might be helpful:
|
mkeschinger
Total Posts: 73
Joined 10-25-2011 status: Experienced |
Re-direct, i can do that. I was loading the inspire the same way. Just choosing it instead of the xspand.
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
If you still have difficulty loading samples, verify which slot the flash module is mounted to. For a single module, slot 1 is typical, and samples should be directed to FL1. If it’s in slot 2, it will work, but samples will have to be directed to FL2 in that case.
The Yamaha Editor won’t - see:
No problem. |