Old Motifator threads are available in the Archive.
rlared
Total Posts: 26
Joined 01-19-2013 status: Regular |
If I am in performance mode, is there a way I can either assign a low pass or high pass filter to the entire performance and use a foot controller to sweep the cutoff? Is there a way to accomplish this in voice mode? |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
Although discussed from a MOXF perspective, you might find these threads interesting:
For Voice mode see [F4] CTL SET (Controller Set) on page 32 of the MOX Reference Manual. As per the MOX data List, Controller Set Destination 98 is Cutoff Frequency. |
rlared
Total Posts: 26
Joined 01-19-2013 status: Regular |
Thanks for the reply. Looks like there’s no simple way to assign it on a per-performance basis. That’s a shame! The killer is that there’s a knob to adjust cutoff but there’s just no way to assign a foot controller to control it. |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
That depends what you mean by “per-performance”. The Assign 1 (AS1, CC#16) and Assign 2 (AS2, CC#17) knobs can be assigned in a Voice to Destination “cutoff” - see my previous post above. In Utility mode a Foot Controller could be set to CC#16 or CC#17 - see page 146 of the MOX Reference Manual. With those settings the Voice used as a Part in a Performance could have its cutoff controlled by foot. The Receive Switch settings (page 69) would determine which Part(s) respond. Perhaps that would meet your needs. |