Hello all,
some minutes ago i switched to “lurch” base in perform mode to rap some word over it and i noticed the voice exits from one only of the speakers ( Yamaha hs50m).
Right one or left one depending by the mic connected to R or L A/D input hole.
The strange is that in voice mode and master i hear mic from both speakers..
I tried with utility section but don’t find solutions.
Some advice would be very appreciated.
Thanks a lot

Salvo

I correct myself. .If i put mic on L connector i hear on right speaker. R connector left speaker. Perform mode

salvosound - 24 October 2015 06:54 AM

Hello all,
some minutes ago i switched to “lurch” base in perform mode to rap some word over it and i noticed the voice exits from one only of the speakers ( Yamaha hs50m).
Right one or left one depending by the mic connected to R or L A/D input hole.
The strange is that in voice mode and master i hear mic from both speakers..

The default condition is for the A/D input to be set to “stereo”, so a signal applied to the L input will appear at the L output, and similarly for the other channel.

In Voice mode there’s a Utility setting that will affect all Voices…
Press [UTILITY], [F4], [SF1]
Set A/D Input, Mono/Stereo to “L mono” or “R mono”, as needed.

For Performances or Song/Pattern Mixes, the setting is done per Program.
For a Performance (or a Song/Pattern Mixing)…
Press [EDIT], [COMMON EDIT]
Press [F4], [SF1]
Set A/D Input, Mono/Stereo to “L mono” or “R mono”, as needed.

How Masters operate depends on the associated Program.

salvosound - 24 October 2015 07:36 AM

I correct myself. .If i put mic on L connector i hear on right speaker. R connector left speaker. Perform mode

It seems you have the channels swapped somewhere in your setup.

Thank you 5pin meawhile i had worked into the utility menu setting the mic options both to stereo and magically now i hear both speakers from mic in all 3 modes but likely is temporary luck!
So i will take in great consideration your suggestions! ;)