Old Motifator threads are available in the Archive.
sethlit
Total Posts: 12
Joined 09-19-2009 status: Regular |
I searched around a bit and couldn’t find an answer, sorry if this has been covered before. I’m using my Motif 6 as a midi controller in Pro Tools 11, things are working good. But...is there a way I can assign the “CS1/Zone1, CS2/Zone2, etc, as specific CC’s? It sure would be nice to be able to assign those sliders to specific VI parameters. Thanks for any info you might have, much appreciated. -Seth |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
If you can use Master mode, then the Control Sliders can have specific CC numbers assigned (in the range 1~95). See page 273 of the Motif6/7/8 Owner’s Manual. |
sethlit
Total Posts: 12
Joined 09-19-2009 status: Regular |
Worked like a charm! I was missing out by not having it in “zone” via edit while in Master mode. Thanks so much! Seth |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
You’re welcome - I’m glad that did the trick. |