Old Motifator threads are available in the Archive.
johnnypro
Total Posts: 2
Joined 11-01-2013 status: Newcomer |
Hi,
Thanx in advance. JP |
Bad_Mister
Total Posts: 36620
Joined 07-30-2002 status: Moderator |
The architectures of the MOX-series and the MX-series is different. We are sure you mean you have Favorite Voices, and Favorite Performances (as “Patches” on the MOX are only found in the PATTERN mode sequencer > [F4] PATCH). The FAVORITE CATEGORY allows you to select a Favorite sound in each Category when selecting programs via the front panel buttons.
What you will do in the MX, which is always in PERFORMANCE mode, is place your Favorite Voices on each of the 16 buttons of the current PERFORMANCE:
Press the [PART SELECT] button (far right front panel)
As you highlight a PART, it button lights, you can use the UP/DOWN CURSOR to move the highlight in the screen to select CATEGORY, then VOICE NUMBER, etc. Learn to navigate with the UP/DOWN cursor (not the LEFT/RIGHT cursor)… so that you can assign your Favorite Voice to the buttons of this PERFORMANCE (PARTS 1 and 2) might be combined by the LAYER or SPLIT buttons, the RHYTHM PART may be accessing Drums from PART 10… but the other PARTS 3-9, and 11-16 are yours to customize as your “local Favorites” to go with this PERFORMANCE. Each of your 128 PERFORMANCE can recall 16 of your Favorite Voices on the PART SELECT buttons [1]-[16]. In actual, use you may need several sounds in a particular composition while performing on stage.
Place them together in a PERFORMANCE as you require. If you are using the VYCRO MX PERFORMANCE Editor you can even setup so you are triggering multiple sounds on a single MIDI channel as you require.
Hope that helps. |
johnnypro
Total Posts: 2
Joined 11-01-2013 status: Newcomer |
So if I save the 16 patches I use in a show to a Performance, then I can access them during a show, even thru MIDI?? I would be using the MX on top of my MOX8 midi-ed. Or would I have to save them in the patch with the same midi channel. |