Old Motifator threads are available in the Archive.
tony higgins
Total Posts: 9
Joined 10-23-2008 status: Newcomer |
Any help would be appreciated ! When local control is switched to off on my xf8, the note C1 only triggers when i use a note on value higher than 74 ( 74-127) , does anyone know what setting would cause this in logic . When i play the note softly (0-73) the midi inspector window registers the event as C1 off (no note on value can be seen)
Just done a test in the event editor which shows as follows
Would this be a logic issue or a yamaha xf 8 issue
My setup is Xf 8 with logic 9.1.8
|
Bad_Mister
Total Posts: 36620
Joined 07-30-2002 status: Moderator |
When LOCAL CONTROL is switched OFF, it is impossible for the KEY C1 to trigger anything internally in your Motif XF8, sorry. If it is triggering something it is due to improper routing of the MIDI signal. This includes: MIDI is sent OUT via USB-MIDI, mLAN_MIDI or 5-pin MIDI (depending on how you have the MIDI IN/OUT parameter set). And it arrives in your software where you must be echoing it back to the Motif XF8. LOCAL CONTROL OFF breaks all connection between the internal XF keyboard and the internal XF tone engine. So your error is in MIDI routing. Also possible is that you have USB-MIDI or mLAN-MIDI setup so that REMOTE messages (normally isolated on PORT 2) mixed in with your musical data (normally isolated on PORT 1) - this can cause all manner of odd results. But either way it is a MIDI routing issue. Hope that helps you track it down. |