Old Motifator threads are available in the Archive.
vo.van
Total Posts: 24
Joined 12-26-2011 status: Regular |
Hi All, thanks again for the great support provided on this forum. I would highly appreciate an advise where to find tutorials or videos for the loops recording on internal sequencer; and how to arrange the loops along of the track. |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
I’m not sure what you are asking for. Perhaps these will help:
|
vo.van
Total Posts: 24
Joined 12-26-2011 status: Regular |
Thanks 5pinDIN, second link was very helpful. I would like to create at least some portion of drums without build-in arpeggio by recording loops and pasting in required location. Is it possible to copy/paste in song or pattern mode? |
MarPabl
Total Posts: 560
Joined 09-08-2011 status: Guru |
Of course =D Take a look at the JOB button for SONG/PATTERN and also read those articles:
|
vo.van
Total Posts: 24
Joined 12-26-2011 status: Regular |
Thanks! there was a link on above pages http://www.motifator.com/storage/support/DrumConstruction.pdf That’s it! Excellent,much appreciated! |
Bad_Mister
Total Posts: 36620
Joined 07-30-2002 status: Moderator |
Although created on a Motif XS this tutorial from the Motif XS SUPPORT area is on point.
|
vo.van
Total Posts: 24
Joined 12-26-2011 status: Regular |
Thanks Bad_Master! That one has actual X0A file included, very handy!
Just a side note - apparently sequencer on XF is very similar to XS.
|
vo.van
Total Posts: 24
Joined 12-26-2011 status: Regular |
Going through tutorials - how to assign empty waveform number (silent)in my edit-key setup - is any empty (silence) form in PRE banks? Thanks |
dereknae
Total Posts: 485
Joined 03-16-2009 status: Enthusiast |
I don’t think there’s much of a difference,flash and an extra userbank..But,other than that it’s all the same.. |
vo.van
Total Posts: 24
Joined 12-26-2011 status: Regular |
while going through tutorials, there is a clip assigned to each key in C3
for some reason, black keys dosen’t stop playback. I tried to re-set a “- - - - - - - “ wave form to black key - nope, still dosen’t. Should I have an actual wave flat form for to do that? |