I have the DX and VL cards installed.
Can´t understand how I select 1 or 2 PLG parts in performance.
I can select all the internal banks but not the PLG-banks.
Did a search here, checked the manual...don´t get it.
Both cards works fine in voice mode.

What am I doing wrong?

Please help !!!

The PLG Boards have their own Slots and those slots have their own PARTS.

In a typical Performance you can have 4 PARTS. A Voice occupies a Part. You can select:
_4 internal Parts
or you can select
_3 internal and 1 PLG Part
or you can select
_2 internal and 2 PLG Parts (if you have two PLG150 boards)
etc., etc. Any combination that is a maximum of 4 PARTs.

Here’s how you do it

Call up PERFORMANCE mode
You do so by holding [SHIFT] + [MULTI] = PERFORM
Select a location you want to work with - it does not matter as nothing is permanent until you choose to STORE the Performance
Press [UTILITY]
PAGE [>] to the final page JOB SEL (Job Select)
Highlight the top Job “Initialize”

For example, say you want to build a Performance with 2 Internal PARTS and your PLG150-DX which is in slot 1. (follow these step… you must Initialize a Performance, then initialize it to the PARTS you want to use… Yes - you must setup the INITIALIZE screen twice. Once for the workspace, the second time to configure the workspace). Here are the step-by-step instructions:

http://forums.keyfax.com/user-files/296215-Details.JPG