Old Motifator threads are available in the Archive.
rajaman
Total Posts: 39
Joined 02-15-2009 status: Regular |
Need your advise with Pattern Chain Mode. I’ve already recorded my pattern (in pattern chain recording,of course) on the XS. But I want to add the last Section to the end of the pattern. That is, I want to repeat the last section so that it repeats. For example, the last section recorded was my Section I which goes from measure 150-179. In essence, I want to duplicate that section so that it repeats in Section J. (Or better yet, Section I would play twice instead of once). When I go to Pattern Chain Edit, two of the available options include INSERT and COPY. As I stated above my Section I ends on measure 179. How do I find out what measure Section J begins on? Or how do I duplicate one section to another? I believe I can either do an INSERT or a COPY, but I don’t know which to use. Hope I’m explaining myself adequately enough for a response. It’s probably simple, but… Thanks for your help. |
Bad_Mister
Total Posts: 36620
Joined 07-30-2002 status: Moderator |
What you need to know about is the ‘END’ command. What the END command does is it tells the Chain when to Stop. If you do not place an “END” command your last entered Section will play just once.
So if SECTION I goes from measures 150 - 179 and you want it to repeat measures 180 - 209…
You will notice that you can insert SECTION letters A, B, C, etc., through letter P, using your DATA WHEEL just beyond letter P is the “END” command… Press [F6] SET It is not necessary to insert another letter I, the last entered Section will continue to play until the END command is reached. Hope that helps. |