Old Motifator threads are available in the Archive.
cal900
Total Posts: 33
Joined 08-12-2013 status: Regular |
Greetings! Is there a way to record a transport “stop” into a Motif XF sequence by a control change message or the like? I looked around for a while, but it seems to evade research. |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
There are System Real-Time Messages…
However, depending on what your needs are, there’s something that might do the trick. The foot switch can be used to start and stop a sequence. To do so, the switch should be connected to the ASSIGNABLE FOOT SWITCH jack, and Foot Switch Control No. in Utility mode should be set to “097 Play/Stop”. See page 230 of the XF Reference Manual. Set up that way, first depression of the switch will start the sequence. The next switch operation will stop/(pause) the sequence. Depressing the switch again will continue the sequence from the point it was paused. And so on… Of course, the XF’s SEQ TRANSPORT controls will still operate, so if you need to restart the sequence from the beginning you can just press the [â–â—„ ] button. |
cal900
Total Posts: 33
Joined 08-12-2013 status: Regular |
This is exactly what I needed. The footswitch answer is a better way to cure the problem than I ever would have expected to be available. Thanks so very much 5pinDIN. I appreciate all the time taken to think of the answers of so many of these problems, and then take the time to type out the solutions. You’re a rock star to so many in the Motif Community! God bless you! |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
I’m glad that was helpful, and thanks for the kind words. |