Hello

I have a question how i can block orders from my keyboardkeys to my cubase elemtent 10. For example if i push a E key or a F key it chance windows in cubase.
And when i push my sustainpedal it mute an audio track in cubase.

The problem is caused by incorrect MIDI port setup - Inputs should be Port 1 (Yamaha MOXF6/MOXF8-1) and possibly Port 3 (only if there’s another keyboard connected to the MOXF’s 5-pin MIDI-in). Make sure Ports 2, 4, and 5 are not selected.

For Remote Devices, only Port 2 (Yamaha MOXF6/MOXF8-2) should be active, both for In and Out. Ports 1, 3, 4, 5 should not be selected.

See MIDI channels and MIDI ports on page 54 of the MOXF Owner’s Manual.

Hello 5pinDIN,

I’ve got it. I have change in utility of th moxf under the midi (F6 buton) the “KBDTransCh” change from “1“ to “OFF”

Problem solved

Thanks a lot,

I’m so sorry it is’nt solved.

Sorry i have change it in channel 16 because otherwise i don’t get a midi signal in my cubase

johpat - 13 April 2020 11:07 AM

johpat - 13 April 2020 11:07 AM

Hello 5pinDIN,
I’m so sorry it is’nt solved.

Yesss 5pinDin

I have change Remote Device midi input and outtput in Yamaha MOXF6/MOXF8 8-2 and its work

Thanks

Only if push my sustainpedal it mut an audio track

johpat - 13 April 2020 12:40 PM

Only if i push my sustainpedal it mute an audio track

johpat - 13 April 2020 12:40 PM

Only if push my sustainpedal it mut an audio track

The cause may be routing of a Generic Remote Device. If you’re not using it, set its MIDI Input to “Not connected”.

Thank you 5pinDin