Old Motifator threads are available in the Archive.
ncc500
Total Posts: 3
Joined 04-01-2019 status: Newcomer |
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
The third byte in the message…
I set it to 10 in the message because that’s for device number 1, which is the default setting. Normally there’s no reason to change that setting in the MOXF, unless you have multiple MOXFs.
The more general case is…
If for some reason you’ve changed the device number setting in the MOXF, then change that byte to match what you set.
Examples:
MOXF setting…
|
ncc500
Total Posts: 3
Joined 04-01-2019 status: Newcomer |
Thank you! Thank you! ThankYou! It was set to 14 (now idea why). I reset it to 1, and it works as you defined. Again thanks and I owe you. Not sure if you can send me a direct email, but if you can I will send you details on what I’m doing. |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
You’re welcome!
Â
You don’t owe me anything - thanks is quite enough. (The folks at Motifator/Keyfax, however, would likely appreciate your support of the forum by making any purchases of MOXF-related material from the Motifator Shop, should the need arise. I personally have no connection - I’m just a forum member.) If absolutely necessary, you could send a PM (Private Message) to me. However, I strongly prefer any discussions be made on the forum, so that others may benefit from the information. |