Old Motifator threads are available in the Archive.
maxweb
Total Posts: 77
Joined 01-06-2004 status: Experienced |
Sorry if this is the wrong section,
When I use that preset for the first time it works (AF1&2;off)
But,
It is impossible to go back to the “original sound”, it works just with AF1 ON. What’s wrong? Thanks for the reply. Max. |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
I checked that Voice on my XF6, and on my XS6 (which has the same Voice) - I’m not experiencing any problem. AF1 is programmed to increase cutoff and resonance, which it does when pressed. When AF1 is pressed again (turned off), cutoff and resonance go back to the original level and the Voice plays as it did before pressing the button. Do you hear the cutoff and resonance increase when AF1 is first pressed? Are you playing PRE 3:051(D03) in Voice mode, or as a Part in a Performance, Song, etc.? Do you have anything connected via MIDI (5-pin, USB, or FW)? |
maxweb
Total Posts: 77
Joined 01-06-2004 status: Experienced |
Thanks for the reply.
I just press AF1 and I hear the cut off and resonance increased, but when I switch off AF1… NO sound.
My firmware is 1.12
PS the problem is in all sounds!! I switched off and on.the motif but the problem is still here!!
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
Your OS version is very old - 1.12 was the first update after 1.00. The current version is 1.50. I don’t know if that has anything to do with what you’re experiencing, but there have been many fixes and new features added in versions 1.20, 1.30, 1.40, and 1.50. The first thing I would suggest is to save an “All” file with samples. If you have a lot of samples installed on the flash modules, that can take quite a while, so be patient. Next, I’d do a factory reset, and see if the problem is resolved. If it is, there probably was a system setting that got changed when you loaded the samples.
I would also suggest that you update the OS. You can go directly from 1.12 to 1.50 - be sure to read the Readme file that comes with the download.
|
maxweb
Total Posts: 77
Joined 01-06-2004 status: Experienced |
As usual many thanks, 5pinDIN. I found the problem, it was an all file that I loaded, AF1 was working like main volume for the voice… I have to understand in which way… |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
You’re welcome.
Â
Here’s a way that can happen…
The default setting for AF1 is CC#86. |