Old Motifator threads are available in the Archive.
ramunas
Total Posts: 3
Joined 10-08-2012 status: Newcomer |
I would be grateful if you could advise me where I am going wrong.
Specifications. Keyboard: Motif XS7, installed FW16E, updated firmware version 1.60.1, it shows mLan in Utilities not FW, set to Logic.
Computer: MacBook Pro OS X 10.7.5, yamaha Steinberg fw v170 drive installed - it’s possible to open the window with blank fields of ‘Sample rate’ and ‘World Clock master’. I also installed studio manager, motif xs editor and IEEE1394 firmware updater which does not find Motif XS7.
|
Bad_Mister
Total Posts: 36620
Joined 07-30-2002 status: Moderator |
First lets locate the Driver in your Mac.
Go to System Preferences
You say you have blank fields. This means there is no connection between your computer and the Moti XS7’s FW16E.
Set the Motif XS to automatically load the following preference:
Set the Motif XS to MIDI IN/OUT = mLAN. Here’s how:
Let us know if you are successful with these steps. |
ramunas
Total Posts: 3
Joined 10-08-2012 status: Newcomer |
Thank you very much for very prompt and accurate instructions! I was not pressing AUTO LOAD and did not have the driver set to FW. Now the communication between Mac and Motif is established and the Steinberg FW drive is easily detectable on Audio Midi Setup!! Thank you again!! |
Bad_Mister
Total Posts: 36620
Joined 07-30-2002 status: Moderator |
No problem. Here is something you need to know. This setting found on the AUTO LOAD page, will store your preference of using the Motif XS with the (newer) FW driver (rather than the older mLAN driver). This preference - is STORED to the Motif XS’s internal FLASH ROM, and like all of your UTILITY mode settings will be backed up in any “ALL” data file (.X0A) that you create (from this point on). However, if you have older ALL data files (.X0A) or if you load an ALL data file created by someone other than yourself (like a Sample Library), be aware that you will want to LOAD it using the TYPE = ALL WITHOUT SYSTEM. The “IEEE1394 Driver = FW” Preference is apart of the SYSTEM settings - so you will want to load other people’s files “without” changing your System, make sense? Even your previous ALL data files will have the mLAN setting stored. So next week when all of a sudden you are back wondering why things are not working - this is the culprit.
RECOMMENDATION: Update your older files with your new preference…
Hope that helps. |
ramunas
Total Posts: 3
Joined 10-08-2012 status: Newcomer |
Thank you for a very efficient service. That is very helpful to know! |