Old Motifator threads are available in the Archive.
julkeys
Total Posts: 24
Joined 01-07-2009 status: Regular |
I know that the effects for a voice must be copied into a performance but with a specific voice I’m having trouble getting the voice to sound that same in Performance mode as it does in Voice mode. I have a Motif Classic and I’m putting the Eyeliner voice (Pre 3 on my keyboard) into a performance. I started from scratch and created a new performance. the only voice is the eyeliner on track 1. I then followed the instructions I found from a post in this forum (Some insert effects don’t work in performance mode). So basically I did the following:
I entered Performance mode.
I set the following:
Type = Part 1
PRess Enter I do copy again this time setting:
Type = Part 1
I then go into the Performance and edit setting the Reverb sent and Chorus send to the settings that are on the voice. However, the eylinver voice in the perfromance still sounds ‘thin’ compared to the original. Is there something else I need to do? When I’m using the F3 function in JOb should the performance be listed at the top. Basically it;s saying I’m copying the performance to current (which is the performance). so I’m not sure how the effects from the original voice are being copied. |
Louder_Than_Good
Total Posts: 302
Joined 07-30-2002 status: Enthusiast |
I think in the Motif Classic one Voice maximum could be brought over with all its effects via: PERFORMANCE EDIT >> COMMON >>F6-SF!>>EF PART ... But don’t bank on this to be gospel, wait for the smart folks to clarify! |