Old Motifator threads are available in the Archive.
JacobZ06
Total Posts: 24
Joined 02-13-2019 status: Regular |
Is there a straight forward approach to “cherry picking” a few selected voices from an “ALL” Voice Library and storing them by replacing some rarely used voices in the factory supplied User1-User4 banks? I want to end up retaining most factory voices after installing a small selection of new voices. Can this be done with Motif XF Editor stand alone to create a revised voices file for later loading into the XF, or is this best done on the XF itself? Thanks for your help. Jacob |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
You can certainly load individual Voices from an “All” file into any of the User Voice locations. That could be done either directly on the XF or in combination with the Yamaha XF Editor. You could also load an entire 128-Voice bank from a library into any of User 2/3/4 banks without losing any factory Voices, using load Type “1 bank voice”. When a Motif XF is new or after a factory reset, only the Voices in the User 1 bank are unique - the remaining User 2/3/4 Voice banks hold copies of various Preset Voices (from PRE1~PRE8). |
JacobZ06
Total Posts: 24
Joined 02-13-2019 status: Regular |
Much appreciated. In the FILE section, there doesn’t appear to be a way to change the User Bank, once you have selected which 1 bank voice set to load. But I will try a factory reset and go at it again. I don’t want to lose the User 1 bank factory voices, especially the nice acoustic S6 voices. I want to load the new voices which are tagged as User 1 bank into User 4 bank. |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
No problem.
Â
See Loading a specific Voice or all the Voices of a specific Bank from an “all” or “all voice” file on pages 243-244 of the XF Reference Manual. If you follow that procedure you’ll be able to set both the destination and source banks. Unfortunately, the call-out numbers appear to have been omitted from the screen diagram. For Step 3, (5) the Destination “Bank” setting is directly below the “Type” line on the display - in your case, that should be set to USR 4.
Source Bank selection can be made after highlighting the file by pressing [ENTER] (see Step 5). The display should indicate…
I hope that clarifies things. |
JacobZ06
Total Posts: 24
Joined 02-13-2019 status: Regular |
Many thanks 5pinDIN. It worked. |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
You’re welcome.
By the way, if you’re working in Song or Pattern mode, up to 16 additional Voices can be stored per Mixing:
|