Old Motifator threads are available in the Archive.
bunzi1964
Total Posts: 82
Joined 12-09-2012 status: Experienced |
Hi,
On th Motif I have backed up “all” “with Sample” on FL1 & FL2 , also backed up “ALL” “without sample” per directions on the firmware read me file. After doing the firmware update, do i just load the “All” “with Sample”.......and where do i load this? Just to USER? Im a little confused even after going over the FULLY LOADED video a couple times. I have all kinds of performances and some have samples in the Motif.....I also loaded some voices from purchased libraries that have some sample sounds on the flash cards. Got shows coming up, and i’m afraid to mess up the keyboard, but at some point , i also want the editor to work properly.
Any advice is greatly appreciated!
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
I suggest that you ignore the “Fully Loaded” video, at least in this case. While having an “All” file “with sample” is good insurance, the data on FL1/FL2 is not impacted by doing the OS update, and the “with sample” file shouldn’t be needed. It’s apparent that you read the v150Readme_e.txt file, since you mentioned saving an “All” file “without sample” as directed. Follow the rest of the directions to install the update - after powering the XF off and back on, load the “without sample” file, with the Load options set as explained in the Readme “Updating Procedure” section. |
bunzi1964
Total Posts: 82
Joined 12-09-2012 status: Experienced |
Awesome,
Thanks again!!! |
bunzi1964
Total Posts: 82
Joined 12-09-2012 status: Experienced |
Hi Pin,
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
You’re welcome - I’m glad things went smoothly. |