Im just wondering if you can control the volume of just one part of a patch with a volume pedal. i.e bring up and down the volume of fader number 2

daveybullets - 06 February 2012 02:43 PM

Im just wondering if you can control the volume of just one part of a patch with a volume pedal. i.e bring up and down the volume of fader number 2

Please tell us what you mean by “patch”. Are you in Voice mode, Performance, etc.?

Sorry I’m in perform mode. I have a piano with pads underneath and I want to control the volume of the pad with a volume pedal

Yes. You can set the RECEIVE SWITCH for “EXPRESSION” to OFF for the PARTs that you do not want to respond to the pedal

From your PERFORMANCE
Press [EDIT]
Press buttons [1]-[4] to SELECT the PART you are editing
Press [F5] RCV SWITCH

Here you can activated or deactivate physical controllers for each PART as necessary. Since you want to control the PAD (leave EXPRESSSION checked for this PART, and clear the EXPRESSION box for the PIANO PART).

Now the piano will ignore the FC7 pedal

Press [STORE] to update your PERFORMANCE.

spot on.thanks for that

I have to bring that subject back on top because I need exactly the same behavior for my FC7: control volume for one part, leave the other part untouched.

I exactly followed the steps above and switched off the Foot Controller 1 where my FC7 pedal is plugged in but nothing happens. It still affects the volume.
Any help?

Fc1 controls total volume.  Plug the fc7 into foot controller 2 to assign it.