Old Motifator threads are available in the Archive.
keyman@usa.net
Total Posts: 77
Joined 07-28-2006 status: Experienced |
Hey folks,
|
cmayhle
Total Posts: 3116
Joined 10-05-2011 status: Guru |
To edit a CONTROLLER SET at the VOICE level, see page 61 of the XF Reference Manual, Controller settings—[F4] Ctrl Set(Controller Set). Specifically, see reference paragraph 3 Depth. It outlines how to “reverse” the controller operation. |
keyman@usa.net
Total Posts: 77
Joined 07-28-2006 status: Experienced |
Yes, I had found that entry in the manual before I posted. The behaviour did not respond as I had hoped. I’ll try other values for the parameter but . . .
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
Some details might help… 1) Do you want the MW behavior to be completely reversed? That is, what it previously did with the MW forward should be what it does when fully back, and vice-versa? (If not, please explain.) 2) Can we assume that “Compressed2” is “Compressed 2” (note the spacing) from the DCP “Vintage Keys” library? It’s a Rhodes through a compressor.
If 1 and 2 are correct, then from EDIT mode…
Press [F5](Com LFO) > [SF2](Set)
SAVE the edited Voice to a User location of your choice. |
keyman@usa.net
Total Posts: 77
Joined 07-28-2006 status: Experienced |
Many thanks to cmayhle and 5pinDIN !!
When I read the page that cmayhle quoted I had tried changing the “ . . . ModWheel Depth to -17 (minus/negative 17)“.
The goal was to use this voice in a performance where the initial behavior was that of the unedited voice with the modulation wheel fully forward.
Thanks for both of your expertise and patience.
|
keyman@usa.net
Total Posts: 77
Joined 07-28-2006 status: Experienced |
The voice I have is “Compressed2†without a space.
|
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
Not that it’s important in this case, but the ES version of the Voice from Vintage Keys actually is spelled “Compressd2” - no space, and no “e” before the “d”. The only reason I brought it up at all was to make sure I was providing information about the correct Voice. I’m glad you’ve got things working the way you want. Now that we know we’re discussing the same Voice, I’ll explain a bit more about how the MW operation gets reversed… Changing the Controller Set ModWheel Depth from +17 to -17 just causes the offset to the Destination (C-LFO dpth1) to be reduced (rather than increased) as the MW is advanced. However, the Common LFO Set 1 Depth was originally 0(zero), so reducing it from that value with the MW doesn’t accomplish what’s desired - it has to have an initial depth to which the -17 offset can be applied. I chose 63 because it’s the middle of the possible 0~127 range, and then verified that things worked correctly. If it hadn’t been satisfactory, I’d have tried values above or below 63 until the MW worked as originally programmed, just in reverse. |
keyman@usa.net
Total Posts: 77
Joined 07-28-2006 status: Experienced |
Yes, the voice name is spelled as you stated, “Compressd2â€. Thank you for that full explanation. All the Best! |