Old Motifator threads are available in the Archive.
MarkJohnson
Total Posts: 75
Joined 09-03-2013 status: Experienced |
I have an external controller that I’m programming various SysEx commands for controlling some of the MOXF configurations. One of them is to toggle the MIDI I/O setting from USB to MIDI (i.e., Utility>MIDI>Other>MIDI In/Out). Based on the documentation in the Ref Manual, p. 125, MIDI Parameter Change Table (System), I’m trying to execute the following commands:
F0 43 10 7F 1C 01 00 00 18 01 F7 USB
The MOXF is not responding to either of these commands. I’ve tried sending them from the PC as well as from the external controller. Any ideas? Thanks Mark |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
In case anyone else is trying to follow along, that would be in the MOXF Data List.
Â
There are two considerations.
2)
Conversely, when the MOXF is set to receive via USB, you can send the message to select 5-pin MIDI via USB, and the MOXF will switch to that. Once done, the MOXF will only respond via 5-pin MIDI. In other words, you can’t toggle the setting back and forth just by changing the data byte, unless you keep switching the port you’re sending the message to as well. |
MarkJohnson
Total Posts: 75
Joined 09-03-2013 status: Experienced |
Yep, that worked. Thanks so much! |
5pinDIN
Total Posts: 11891
Joined 09-16-2010 status: Legend |
You’re welcome! Glad that did the trick. |